Symbol Stb4278 Setup Sheet11/17/2020
The STB-4278 cradle receives data from the scanner via a Bluetooth radio, and sends that data to the host computer through an attached cable.The STB-4278 also recharges the internal battery pack when the scanner is resting in the cradle.Possible solution: Make sure all cable connections are fixed.
Symbol Stb4278 Setup Sheet Code Scanner FromBelow we mainly explain the problems that are common to the Symbol LS4278 barcode scanner from the problems that occur in the scanner, as well as the status of the problem and the appropriate solution.Possible reason: The battery is above or below the normal operating temperature. Move the barcode scanner to a position where the operating temperature is normal. The barcode scanner can continue to be inserted into the cradle while warming or cooling the battery to normal operating temperature. Phenomenon 2: The barcode scanner does not respond after pulling the trigger switch. Possible reason 1: The Symbol LS4278 barcode scanner is not powered. Possible solution: The battery may have been discharged; please use the cradle to charge the barcode scanner. Check that the battery cover is closed and that the end cover of the battery compartment is secure. Possible reason 2: The Symbol LS4278 barcode scanner is disabled. Possible solution: Some host interfaces (such as Synapse, IBM-468x) can disable this barcode scanner. If applicable, enable the barcode scanner via the host interface. Phenomenon 3: The laser can be emitted, but the symbol cannot be decoded. Possible reason 1: Symbol LS4278 barcode scanner does not be programed by the correct barcode type. Possible solution: Make sure the barcode scanner is programmed to read the type of barcode you want to scan. Possible reason 2: Symbol LS4278 bar code symbol is not readable. Possible solution: Check the symbols to make sure the symbols are not defective. Possible reason 3: The distance between the Symbol LS4278 barcode scanner and the barcode is not suitable. Possible solution: Move the barcode scanner closer to or away from the barcode. Phenomenon 4: The symbol has been decoded, but cant be transmitted to the host. Possible reason 1: Symbol LS4278 does not program the communication cradle according to the correct host interface. Possible solution: Check the barcode scanner host parameters or editing options. ![]() Possible solution: Pair the barcode scanner with the charging dock (using the pairing barcode on the charging dock). Possible reason 3: The interface cable of the Symbol LS4278 barcode scanner is loose.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2020
Categories |